全新 DJS-II/C供货商

时间：2021-10-12

全新 DJS-II/C供货商

When the lightning arrester flows through lightning wave, operation wave or power frequency overvoltage, the strong action current will be transferred from the leakage current measurement circuit to the counter circuit, and the leakage current measurement circuit is protected. The counter part uses the principle of electromagnetic induction to obtain the ** of operation wave or power frequency overvoltage current, and then processed by the microprocessor in the display to record the number of actions
Method of use1. Connect the corresponding wiring according to the operation manual;　2. When powered on, the LCD is displayed in turn according to the sequence of phase a counting, phase B counting and phase C counting;　　3. Short touch the "F" key to check phase a count, phase B count, phase C count, local address, current date and current address in turn　Time, when the current time is displayed, if it is djs-ii type, press the "F" key three times to zero the leakage current value (please pull out the data cable during zero calibration).

Data can be downloaded and analyzed with special software through mobile computer and 485-232 transfer interface.　Overall dimension, installation method and wiring diagram　　Overall dimension

Scope of application: 3 ~ 35kV system discrete lightning arrester without (with Series) gap; 2. Power supply: AC / DC 110 ~ 220V, ＜ 1.5W;3. Counting form: A, B and C phases are counted separately and displayed on centralized LCD; 4. Minimum capture discharge current: ＜ 10A; 5. Minimum capture pulse width: ＜ 1 μ s； 6. Leakage current monitoring range: 0 ~ 20mA; 7. Built in clock, power failure holding time: half a year; 8. Storage capacity: ＞ 2000 pieces;　　9. Communication interface: 485, class Modbus protocol; 10. Independent address code can be set

Long press the "F" key, then "CLR" will prompt whether all counts are cleared, and "-" will be displayed. After a "-" appears　　Execute the reset operation, and release the "F" key to exit before a "-" appears; 5. After pressing "▲" and "▼" at the same time to enter the setting state, the "year" bit flashes first, which can be adjusted by up and down keys; adopt　Short touch "F" to switch to "month", "day", "hour", "minute" and "second" in sequence. When the second adjustment is over, short touch "F" to display the address code of the counter. If adjustment is needed, press "▲" and "▼" to adjust, and the adjustment will take effect immediately; During the adjustment, if the operation stops at any position for more than 7S, the standby state will be restored automatically, and the previous adjustment is effective. 6. Relevant data can be managed by background software through 485 bus;
通过移动计算机和485-232传输接口，可使用软件下载和分析数据。