斜螺杆包装机 50kg摇臂式包装机

时间：2023-08-04

敏正电子的NTC热敏电阻器系由特殊配置的金属氧化物陶瓷材料制成，它可用来抑制高的突波电流。相对于受保护电路,热敏电阻器具有较高的电阻。因此会抑制突波电流约1~2秒，在这一段时间内热敏电阻的电阻将因温度升高而下降，直至热敏电阻两端压降到可被忽略的电阻值为止。如图A以电源供应器为例, 在电源开的瞬间，电容器一般阻抗较低，桥式整流器通常承受很大的电流，热敏电阻器特别使用于保护电源供应器。
Shanghai mec  electronic  NTC Thermistor devices are made of a specially formulated metal oxide ceramic material which is capable of suppressing high inrush current surges.
Thermistor devices, being of relatively high resistance, shall limit the inrush current for 1~2 seconds during which time the device decreased in resistance substantially to a point where its voltage drop is negligible .The devices are especially useful in power supplies (see Fig A) because of the extremely low impedance of the capacitor being charged, of which the bridge is ususlly subjected to an exceedingly high current surge at turnon point.
特征
●有效抑止突波电流。
●稳定状态下功率损耗较小(通常仅有1W或小于50W)。
●热及电特性稳定性高。
●宽广的电性规格可供选择。
FEATURES
●High inrush current restriction effect
●Small power loss in stationary state
●(Normally less than 50W power)
●High thermal and electrical stability.
●Wide selection of electrical performances
应用概述
如图B所示，将一NTC热敏电阻与一白热灯丝串联时，可以消除突波电流。若一只NTC热敏电阻无法提供足够之突流限制功能时，二只或更多的热敏电阻可用于串联电路上或供应电路的各个分路上(如图A)。但要注意的是NTC热敏电阻，不可并联于电路上，因为其中一只NTC就可能会传导几乎所有的电流。热敏电阻较好用于图A所示AC电路的A1或A2处，或是DC电路D1或D2处。
在设计上，当电路刚被打开的瞬间，NTC热敏电阻的阻值**电路上所有白热灯丝的总电阻值。当电流开始通过时，热敏电阻随时产生「自然」现象，并在1到2秒内，阻值会降到几可忽略。以同样的构想来看电动马达的突波电流，亦可以被抑制到较低限度。图C表示应用热敏电阻保护直流马达前后突波电流波形的差异。
APPLICATION
As shown in Fig.B, the current surge can be eliminated by placing a NTC thermistor in series with a filament string. Yet, if the resistance of one NTC thermistor does not provide sufficient inrush current limiting functions for your applicantion, 2 or more may be used in series or in separate legs of the supply circuit (Fig.A). Be noticed, the thermistor can not be used in parallel since one unit will tend to conduct nearly all the current available. Thus, thermistor may be used in the AC (point A1or A2)or the DC (point D1or D2) locations in the circuit. (see Fig.A)
The resistance of NTC thermistor is designed higher than the total resistance of NIC thermistor is designed higher than the total resistance of filaments when thermistor shall immediately self-heat. Then, in 1~2 seconds, its resistance will be reduced to a minimum and become insignificant to the total resistance of a circuit. With the same concept, current surges in electric motors can be held to minimum. Fig.C shows a typical DC motor's turn on surge before and after the application of a thermistor to the circuit
选用原则
1.热敏电阻器的较大工作电流＞实际电源回路的工作电流
2.热敏电阻器的标称电阻值
R≥         式中E为线路电压  l m为浪涌电流
                对于转换电源、逆变电源、开关电源、
                UPS电源l m=100倍工作电流
                对于灯丝、加热器等回路l m=30倍工作电流
1.Maximum operating current >Actual operating current in the power loop
2.Reted zero power resistance at 25℃of which, E: loop voltage, lm: Surge current.
For conversion power, reversion power, switch power,

词条
词条说明
25公斤防爆型包装机-立式转阀料斗包装机
25公斤防爆型包装机-立式转阀料斗包装机上海广志自动化设备有限公司主营产品有腻子粉包装机、圆角条袋包装机、半自动包装机、单斗重力式包装机、活塞式包装机、等，具有、稳定、可靠等特点。我们始终坚持以客户为中心，以质量为先，以技术为支撑，助力客户实现商业目标。●: 气动阀口（可选）●: 超声波（封口）阀口（可选）●: 叶轮式/气浮式（可选）●: 螺旋阀口（可选）●: 螺旋
强酸分装机-100L强酸强碱分装机
强酸分装机-100L强酸强碱分装机我们公司提供乳胶漆灌装机、稀释剂灌装机、纯丙乳液灌装机、称重灌装机、液面下灌装机等多种成套包装设备。我们拥有*的技术团队和售后服务，能够为客户提供专业、的解决方案，满足不**业的需求。强酸分装机-100L强酸强碱分装机的参数：灌装容量：60-200L灌装速度：80-120（桶/小时）,按20公斤计灌装精度：≤±0.35%FS供电电源：220/380V气源压力：0
1000KG升降式包装机双头包装机优质供应商
1000KG升降式包装机双头包装机上海广志自动化设备有限公司-主要经营-干粉砂浆装机、粉末包装机、颗粒包装机、腻子粉包装机、耐火材料包装机、水泥包装机、粉状包装机、沙子包装机、袋装包装机等等包装线设备厂家1000KG升降式包装机双头包装机应用行业 :矿产、化工、建材、粮食以及饲料行业的物料大袋包装。1000KG升降式包装机双头包装机的类型:●: 气动阀口（可选）●: 超声波（封口）阀口&n
自动压盖包装机 1000KG升降式包装机
自动压盖包装机 1000KG升降式包装机我们生产和销售粉包装机、螺旋包装机、双口气压式包装机、阀口袋包装机、全自动高速包装机、等设备，广泛应用于各种行业。我们拥有专业的技术研发团队和完善的售后服务体系，可以为客户提供优质、的解决方案。●: 气动阀口（可选）●: 超声波（封口）阀口（可选）●: 叶轮式/气浮式（可选）●: 螺旋阀口（可选）●: 螺旋敞口（可选）●: